Nozzle clogging

If the precision atomizing nozzle is used for a long time, or the use environment is poor (such as more dust in the air), it is easy to block. At this time, you can remove the nozzle and clean it with cleaning liquid or remove the blockage in the nozzle with a needle.

 

Nozzle casing loose

After a period of use, the shell of the precision atomizing nozzle may become loose, resulting in gas or liquid not being able to enter the nozzle smoothly. At this point, you can re-tighten the nozzle housing so that it can work smoothly.
 

Improper nozzle position

The position of the precision atomizing nozzle will also affect its spray effect. If the nozzle position is too high or too low, it may cause the nozzle to not fog. At this time, the nozzle position can be adjusted according to the instruction manual.
 

Excessive liquid viscosity

The viscosity of some liquids is too high, which may affect the spray effect of the nozzle. At this point, the liquid can be diluted slightly to improve the spray effect.
 

Underpressure

Precision atomizing nozzles need a certain working pressure to spray fog. If the pressure is insufficient, the nozzle will not spray fog. At this time, you can check whether the pressure of the nozzle is normal, and adjust it accordingly according to the cause of insufficient pressure.
 
In short, the precision atomizing nozzle does not fog may be due to a variety of reasons. If you encounter such problems, you can troubleshoot them one by one according to the above methods. If the problem cannot be solved, it is recommended to find the manufacturer or technical personnel to repair.